1. INPUT CHANNELS
LEVEL – Set the input gain level for the respective channel. Set to minimum before connecting an audio signal.
INPUT XLR SOCKETS – XLR and 6.3mm jack combi socket that can be used with balanced or unbalanced signals. Balanced signals provide superior noise rejection over long cable runs.
2. MAIN CONTROLS
MASTER VOLUME – Controls the overall level of the output mix. Set to minimum when
turning the system on and off.
LIMIT LED – All AHP units have an onboard limiter to prevent overloading the amplifier and loudspeakers.
Will illuminate when the limiter is active. Occasional blinking is ok however continuous illumination should be avoided. Turn the input levels and master volume down until it goes off to prevent damage to the amplifier.
MIX OUT – Line level signal not affected by master volume. Can be used to daisy chain multiple units or connect a personal monitor or mixing PA.
3. MODE AND OPTION SELECT
GROUND LINK - Disconnects signal ground from the chassis to potentially remove ground hum.
MODE SELECT – Choose between the four presets included with your AHP full range cabinet depending on your use.
MUSIC – Bass lift with flat mid/high response.
LIVE – Similar to ‘MUSIC’ but the LF lift is shifted to a higher frequency.
MONITOR – LF and HF roll-off with a slight mid band cut for clarity.
VOCAL – Bass roll off with flat mid and upper frequencies.
AHP110
Model AHP110
Type 2-Way Bi-Amp Powered Loudspeaker, Bass Reflex
Frequency Response 48Hz - 20000Hz (-10dB) 55Hz - 18000Hz (-3dB)
LF Driver 10" HH Designed Woofer with 2" Voice Coil
HF Driver 1" Compression Driver
Crossover Frequency 2.5KHz
Coverage 90° x 90°
Max SPL 1m2 127 dB SPL Continuous, 130 dB SPL Peak
Controls 2x Channel Gain Controls, Master Volume, Ground Lift, EQ Mode (4 Options)
Input Connectors 2x Balanced Combi XLR/1/4" Jack connectors
Output Connectors 1x Balanced XLR Mix Output
Input Impedance 10K
Signal Indicators Clip Indicator
Amplifier System Amplifier
Power
Rating 1400W Peak (Biamp)
Amplifier Type LF Class D, HF Class A/B
Power Supply Universal SMPS
Protection Comprehensive protection and clip free limiting + clip indicator
Enclosure Robust Black polypropylene cabinet with monitor angle
Grille Heavy Gauge powder-coated steel, Black with acoustic foam backing
Handles Two Integrated side handles and one top handle
Flying Points 4 x M8 Mounting Points
Pole Socket Bottom 35mm Pole Mount Socket with two angles (0° and 7°)
Power Requirements
AC Power User Switchable 110-120V~ or 220-240V~ 50/60HZ
Power Inlet IEC C14 Inlet Typical
Power Consumption 300W
Other
Unit dimensions (HWD) 541 x 327 x 316mm, (21.3" x 12.9" x 12.4") Unit weight 12.5Kg, (27.6 lbs)
Carton dimensions (HWD) 620 x 390 x 370mm, (24.4" x 15.4" x 14.6") , 0.089 M3
Packed Weight 17.8Kg, (39.2 lbs)
EAN Code 5060109458817